Installation Guide for 16-18 Chevrolet Silverado LUXX-Series & NOVA-Series Headlights
THIS GUIDE IS FOR
NOTE: Some vehicle require the DRL harness installed for the headlight to function properly.
Table of Contents
Disclaimer: This installation article is a tutorial guide. By reading this article, you agree it is for reference only and AlphaRex USA and its distributors make no guarantee on the finished results. Under no circumstances whatsoever shall AlphaRex USA nor its distributors be liable for any damage, misuse or personal injuries. If you do not fully understand the installation procedure, it is highly recommended that you seek help from professional mechanics to do the installation.
INSTALLATION TOOLS
1/4 Ratchet
Metal Panel Popper
Phillips Screwdriver
Flat Screwdriver
1/4 Extension
Socket
Size NEEDED
Socket
(Star Torx)
Size NEEDED
Before we get started
PART I - REMOVE HEADLIGHTS
DISCONNECTING THE NEGATIVE BATTERY TERMINAL
Whenever working on your vehicle always start by disconnecting the negative battery terminal.
REMOVE THE RADIATOR SHROUD
Use a panel popper and start by removing (12) plastic push pins that is holding up the radiator
shroud.
REMOVE THE GRILLE
First, remove 4 X 10mm bolts from the top of the grille.
Next, gently pull the grille towards you to release from the 6 insert mounts. Please set it aside for later reinstallation.
REMOVE THE HEADLIGHT BOLTS
In order to remove the headlight you will have to remove 4 X 10mm bolts. Two bolts on the top, one on the side and one from the inner front bumper.
To gain access to the headlight bolt from the inner bumper, fist remove the 2 X T15 screw from the wheel well.
Then use a panel popper to open the guard cover (widely) so you can gain access to the headlight’s bolt. Use a ratchet and extension socket to help you remove the 10mm bolt. Please follow the same steps for the other side of the headlight.
REMOVE THE HEADLIGHTS
Unplug the headlights socket and pull the headlight assembly outwards from your truck. Please follow the same step for the other side.
PART II - INSTALL HEADLIGHTS
INSTALL ALPHAREX HEADLIGHTS
Reconnect the battery negative terminal and plug the light socket to the new ALPHAREX headlights.
Secure the headlight’s bolts and reverse the removal process to complete the installation.
TEST THE HEADLIGHT FUNCTIONS
Test the functions of your ALPHAREX headlights to ensure everything works properly.
ADJUST HEADLIGHT LEVEL
After headlights installation is complete.
You will next aim the headlight at about 25ft against a wall on a level surface.
Clockwise to lower the level
Counterclockwise to raise the level
Please follow the same procedure for the other headlight.
COMPLETE INSTALLATION
Congratulations! you have completed the installation for ALPHAREX 16-18 Chevrolet Silverado Headlights.
